Search This Supplers Products:PET Preform MouldInjection Molding MachinePlastic MouldSemi-automatic Blow Molding MachineAutomatic Blow Molding Machine
- Home
- About us
- Products
- Best selling injection molding machine
- Preformed preform injection mold
- Production injection molding machine
- All kinds of injection plastic molds
- Semi-Automatic Blow Moulding Machines
- Automatic Extrusion Blow Molding Machines
- Produce cheap laser marking machine
- Custom plastic preform injection mold
- Other injection mold forming machines
- Injection Disposable Plastic Tableware Mould
- Faqs
- News
- Certificate
- Contact us
Countermeasure against deformation in discoid molded product
time2020/08/10
- Generally, effect to the roundness by the gate type tend to be better in the following order.
Side gate ＜ Pin gate（double points） ＜ Pin gate （triple points） ＜ Center sprue gate
Countermeasure against deformation in discoid molded product
（1） Generally, effect to the roundness by the gate type tend to be better in the following order.
Side gate ＜ Pin gate（double points） ＜ Pin gate （triple points） ＜ Center sprue gate
（2） Weld might influence the roundness, especially in GF reinforced grade, so take care of the gate location,
try to mold under a good liquidity condition, and be careful of the mold gas vent.
（3） Deformation towards surface run out direction is often occurred by the shrinkage ratio difference between
diametrical direction and circumferential direction. Other than taking balance in shape, there is a method that place a rib towards circumferential direction to strengthen the stiffness and remedy. The multipoint pin gate is relatively effective against the surface run out.
Figure 3-1 Gate type and roundness of discoid molded product
Figure 3-2 Example of countermeasure against surface run out